Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Kia Telluride EX, FWDFACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (7 Of 12)
- DTC Index
- DTC P0335-00: Crankshaft Position Sensor 'A' Circuit
- DTC P0336-00: Crankshaft Position Sensor 'A' Circuit Range/Performance
- DTC P0340-00: Camshaft Position Sensor 'A' (Intake) Circuit (Bank 1 Or Single Sensor)
- DTC P0341-00: Camshaft Position Sensor 'A'(Intake) Circuit Range/Performance (Bank 1)
- DTC P0345-00: Camshaft Position Sensor 'A(Intake)' Circuit (Bank 2)
- DTC P0346-00: Camshaft Position Sensor 'A'(Intake) Circuit Range/Performance (Bank 2)
- DTC P0365-00: Camshaft Position Sensor 'B'(Exhaust) Circuit Malfunction (Bank 1)
- DTC P0366-00: Camshaft Position Sensor 'B'(Exhaust) Circuit Range/Performance (Bank 1)
- DTC P0390-00: Camshaft Position Sensor 'B' Circuit
- DTC P0391-00: Camshaft Position Sensor 'B' Circuit Range/Performance
- DTC P039B-00: Cylinder 1 Pressure Too High
- DTC P03A5-00: Cylinder 2 Pressure Too High
- DTC P03AF-00: Cylinder 3 Pressure Too High
- DTC P03B9-00: Cylinder 4 Pressure Too High
- DTC P03C3-00: Cylinder 5 Pressure Too High
- DTC P03CD-00: Cylinder 6 Pressure Too High
- DTC P0420-00: Catalyst System Efficiency Below Threshold (Bank 1)
- DTC P0430-00: Catalyst System Efficiency Below Threshold (Bank 2)
- DTC P0441-00: Evaporative Emission System Incorrect Purge Flow
- DTC P0442-00: Evaporative Emission System-Leak detected (Small Leak)
- DTC P0444-00: Evaporative Emission System-Purge Control Valve Circuit Open
- DTC P0445-00: Evaporative Emission System-Purge Control Valve Circuit Shorted
- DTC P0447-00: Evaporative Emission System - Vent Control Circuit Open
- DTC P0448-00: Evaporative Emission System - Vent Control Circuit Shorted
- DTC P0449-00: Evaporative Emission System - Vent Valve/Solenoid Circuit
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
