Circuit Inspection

2021 Kia K5 LXS, AWDSECTION Circuit Inspection
G13806892Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
1. Ignition "ON". C-MDPS connector 7 (C-CAN high) Chassis ground - Fig.1
C-MDPS connector 8 (C-CAN low) Chassis ground -
1. Ignition "ON". R-MDPS connector 4 (C-CAN high) Chassis ground - Fig.1
R-MDPS connector 5 (C-CAN low) Chassis ground -
G13806893Courtesy of KIA MOTORS AMERICA, INC.

Good 

  • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
  • Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.

    * In case of replacing the component, perform following "System Inspection" procedure.

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.