Component Inspection: Notes

2021 Kia Forte GT, Automatic DCT TransSECTION Notes
Inspection Condition Inspection Procedure Reference
  1. Ignition "OFF"
  2. Wait until the brake disc sufficiently gets cold (below 400°C (752°F).
  1. Check the brake pads for wear and fade.
  2. Check the brake disc for damage and deformation.
  3. Check the brake tubes for cracks, crimps and corrosion.
  4. Check brake hose mounting bracket for crack or deformation.
-

Good 

  • Carefully re-do this troubleshooting guide steps.
  • If no problems were found with the circuits or connectors, replace ESC module and then go to "VERIFICATION OF REPAIR " procedure.

    * In case of replacing ESC control module, Perform "Vehicle S/W Management" procedure.

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.