Vehicle S/W Management

2021 Kia Forte GT, Automatic DCT TransSECTION Vehicle S/W Management
Inspection Condition Inspection Procedure Reference
  1. Variant Coding.
  2. Ignition "ON".
  1. Connect KDS to Data Link Connector (DLC).
  2. Perform "Variant Coding" in "Vehicle S/W management" with KDS.
Fig.1 to 6
G13301746Courtesy of KIA MOTORS AMERICA, INC.
G13301747Courtesy of KIA MOTORS AMERICA, INC.
G13301748Courtesy of KIA MOTORS AMERICA, INC.
G13301749Courtesy of KIA MOTORS AMERICA, INC.
G13301750Courtesy of KIA MOTORS AMERICA, INC.
G13301751Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition Inspection Procedure Reference
  1. Longitudinal G Sensor Calibration (HAC/DBC Only).
  2. Ignition "ON".
  1. Connect KDS to Data Link Connector (DLC).
  2. Perform "Longitudinal G Sensor Calibration (HAC/DBC Only)" in "Vehicle S/W management" with KDS.
Fig.1 to 5
G13301752Courtesy of KIA MOTORS AMERICA, INC.
G13301753Courtesy of KIA MOTORS AMERICA, INC.
G13301754Courtesy of KIA MOTORS AMERICA, INC.
G13301755Courtesy of KIA MOTORS AMERICA, INC.
G13301756Courtesy of KIA MOTORS AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.