Circuit Inspection

2021 Kia Forte GT, Automatic DCT TransSECTION Circuit Inspection
G13301585Courtesy of KIA MOTORS AMERICA, INC.
Charging System Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "ON".
  2. Start the engine and turn the headlight, rear window defogger and all other electrical devices.
  3. Measure voltage between (+) terminal and (-) terminal of battery while maintaining engine RPM at 2500 RPM.
Battery + Terminal Battery - Terminal 9 to 16V
ESC circuit inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Disconnect the electrical connector(s) from the concerned component.
  2. Ignition "ON".
ESC module connector 1/6/25 (power) Chassis ground - B+
ESC module connector 13 (ground) Chassis ground - Approx. below 1Ω

Good 

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.