Component Inspection: Notes

2021 Kia Forte GT, Automatic DCT TransSECTION Notes
Inspection Condition Inspection Procedure Reference
  1. Ignition "ON".
  1. Check the brake fluid level.
  2. Check the oil line leakage between reservoir and master cylinder.
  3. Check the oil line leakage between master cylinder and ESC module.
-

Good 

  • Perform the "HCU Air Bleeding Mode" refer to "Shop Information" and carefully re-do this troubleshooting guide steps.
  • If no problems were found with the circuits or motor, replace the ESC module and go to "VERIFICATION OF REPAIR " procedure.

    * In case of replacing ESC module, perform following "Vehicle S/W Management" procedures

No Good 

CAUTION: In case of replacing ESC module, perform following procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.