DTC Information: DTC Detecting Condition

2021 Kia Forte GT, Automatic DCT TransSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Signal monitoring (Rationality check)
  • Poor connector connection
  • Faulty signal circuit of Front-LH wheel speed sensor
  • Faulty wheel speed sensor Front-LH
Enable Condition
  • Ignition "ON"
  • No related DTC is stored
Threshold Value Case1
  • When the difference between the fastest wheel speed and the slowest wheel speed exceeds 10 km/h (6.2 MPH)
Case2
  • When the non-driving wheel speed exceeds 14 km/h (8.7 MPH)
Case3
  • When the signal from the wheel speed sensor is consistently very high or very low
Case4
  • When the pressure drops during ESC operation
Detecting Time Case1
  • 180s
Case2
  • 10s
Case3
  • 28s
Warning Lamp
  • Lamp "ON"
Disable Condition
  • All WSS is normal while driving after ignition "OFF/ON"
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.