Circuit Inspection

2021 Kia Forte GT, Automatic DCT TransSECTION Circuit Inspection
G13301425Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Disconnect the electrical connector(s) from the concerned component.
  2. Ignition "ON".
Front Wheel Sensor LH Connector 1 (power) Chassis ground - B+
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component and ESC module.
Front Wheel Sensor LH Connector 1 (power) Chassis ground - 0V
Front Wheel Sensor LH Connector 2 (signal) Chassis ground - ∞ (infinite)Ω
Front Wheel Sensor LH Connector 2 (signal) ESC module connector 37 (signal) Approx. below 1Ω
Front Wheel Sensor LH Connector 1 (power) ESC module connector 36 (power) Approx. below 1Ω

Good 

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.