DTC Information: DTC Detecting Condition

2021 Kia Forte GT, Automatic DCT TransSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Check the installation angle or perform the calibration
  • BCW installation angle failure
  • Control Module missing calibration
Enable Conditions
  • 2s elapsed after ignition "ON"
  • Normal input voltage condition (C110117/C110216 DTC not generated)
Threshold Value
  • No execution of calibration
  • When sensor installation angle is out of specification range (Β±7.3Β°)
Detecting Time
  • 1s
Symptom
  • BCW fault display in cluster
  • BCW switch LED OFF
Clear Condition
  • Can be released only by diagnostic equipment (can not be automatically released)
Fail Safe
  • Blind spot alert control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.