Circuit Inspection: Notes

2021 Kia Forte GT, Automatic DCT TransSECTION Notes
G13301317Courtesy of KIA MOTORS AMERICA, INC.
G13301318Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
BCW Radar (RH) Connector 1 (power) Chassis ground - B+
BCW Radar (LH) Connector 1 (power) Chassis ground - B+
BCW Radar (RH) Connector 6 (ground) Chassis ground - Approx. below 1Ω
BCW Radar (LH) Connector 6 (ground) Chassis ground - Approx. below 1Ω
  1. Ignition "ON".
ICU Connector 9 (C-CAN high) ICU Connector 10 (C-CAN low) Fig.1
G13301319Courtesy of KIA MOTORS AMERICA, INC.

Good 

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.