Component Inspection

2021 Kia Forte EXSECTION Component Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "OFF"
  2. Disconnect the electrical connector(s) from the concerned component.
Front right door speaker (component side) 1 (FR+) Front right door speaker (component side) 2 (FR-) Approx. 2.0Ω (20°C/68°F)
Front right door speaker (component side) 1 (TWT FR+) Front right door speaker (component side) 2 (TWT FR-) Approx. 3.4Ω (20°C/68°F)

Good 

  • Carefully re-do this troubleshooting guide steps.
  • If no problems were found with the circuits or connectors, replace the A/V & Navigation head unit and go to "VERIFICATION OF REPAIR " procedure.

No Good 

  • Carefully re-do this troubleshooting guide steps.
  • If no problems were found with the circuits or connectors, replace the related speaker and go to "VERIFICATION OF REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.