DTC Information: DTC Detecting Condition

2020 Kia Soul LX, Standard TransSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Calibration monitoring
  • Poor connector connection
  • Yaw rate (Ax) calibration is not performed correctly
  • Faulty ACU
  • Faulty ESC
Enable Condition
  • Ignition "ON"
  • No related DTC is stored
Threshold Value
  • A failure is detected if the zero value calibration for G sensor is not done
  • A failure is detected if the sensor replacement is detected
Disable Condition
  • Calibration complete
Warning Lamp
  • In case 4WD - ESC/DBC/AVH warning lamp "ON"
  • DBC warning lamp is applied: ESC(ESP) warning lamp "OFF", DBC warning lamp "ON"
  • DBC warning lamp is not applied: ESC(ESP) warning lamp "ON", DBC warning lamp "OFF"
Failsafe
  • -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.