Circuit Inspection

2020 Kia Soul LX, Standard TransSECTION Circuit Inspection
G13285605Courtesy of KIA MOTORS AMERICA, INC.
G13285606Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition (+) Probe (-) Probe Specification
connector Terminal connector Terminal
  1. Ignition "OFF".
  2. Disconnect the electrical connector(s) from the concerned component.
Rear wheel sensor RH connector 2 (power) Chassis ground - 0V
Rear wheel sensor RH connector 1 (signal) Chassis ground - ∞ (infinity)Ω
Rear wheel sensor RH connector 2 (power) ESC connector 19 (power) Approx. below 1Ω
Rear wheel sensor RH connector 1 (signal) ESC connector 32 (signal) Approx. below 1Ω

Good 

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.