Component Inspection

2020 Kia Soul LX, Standard TransSECTION Component Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "OFF".
  2. Disconnect battery (-) cable.
  3. Disconnect the electrical connector (s) from the concerned component.
Subwoofer speaker2 (component side) 3(+) Subwoofer speaker2 (component side) 4(-) Approx. 1.8Ω (20°C (68°F))

Good 

  • If no problems were found with the circuits or connectors, replace the AMP and go to "Verification of Repair " procedure.

No Good 

  • If no problems were found with the circuits or connectors, replace the subwoofer speaker and go to "Verification of Repair " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.