Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Removal
2020 Kia Sedona SXSECTION Removal
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
- Remove the floor console.
(Refer to Body - "FLOOR CONSOLE ")
- Pull up the lock of the SRSCM connector, and then disconnect the connector (A).
- Remove the SRSCM mounting bolts (3EA) from the SRSCM, and then remove the SRSCM.
CAUTION:
You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.