2020 Kia K900FACTORY OEM SERVICE PROCEDURE

DTC Index

DTC INDEX

DTC Description
DTC P0266  00: Cylinder 2 Contribution/Balance
DTC P0267  00: Cylinder 3 Injector Circuit Low
DTC P0268  00: Cylinder 3 Injector Circuit High
DTC P0269  00: Cylinder 3 Contribution/Balance
DTC P0270  00: Cylinder 4 Injector Circuit Low
DTC P0271  00: Cylinder 4 Injector Circuit High
DTC P0272  00: Cylinder 4 Contribution/Balance
DTC P0273  00: Cylinder 5 Injector Circuit Low
DTC P0274  00: Cylinder 5 Injector Circuit High
DTC P0275  00: Cylinder 5 Contribution/Balance
DTC P0276  00: Cylinder 6 Injector Circuit Low
DTC P0277  00: Cylinder 6 Injector Circuit High
DTC P0278  00: Cylinder 6 Contribution/Balance
DTC P0299  00: Turbocharger/Supercharger Underboost
DTC P02CC  00: Cylinder 1 Fuel Injector Offset Learning At Min Limit
DTC P02CD  00: Cylinder 1 Fuel Injector Offset Learning At Max Limit
DTC P02CE  00: Cylinder 2 Fuel Injector Offset Learning At Min Limit
DTC P02CF  00: Cylinder 2 Fuel Injector Offset Learning At Max Limit
DTC P02D0  00: Cylinder 3 Fuel Injector Offset Learning At Min Limit
DTC P02D1  00: Cylinder 3 Fuel Injector Offset Learning At Max Limit
DTC P02D2  00: Cylinder 4 Fuel Injector Offset Learning at Min Limit
DTC P02D3  00: Cylinder 4 Fuel Injector Offset Learning at Max Limit
DTC P02D4  00: Cylinder 5 Fuel Injector Offset Learning at Min Limit
DTC P02D5  00: Cylinder 5 Fuel Injector Offset Learning at Max Limit
DTC P02D6  00: Cylinder 6 Fuel Injector Offset Learning at Min Limit
DTC P02D7  00: Cylinder 6 Fuel Injector Offset Learning at Max Limit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.