Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Kia K900FACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (4 Of 9)
- DTC Index
- DTC P0266-00: Cylinder 2 Contribution/Balance
- DTC P0267-00: Cylinder 3 Injector Circuit Low
- DTC P0268-00: Cylinder 3 Injector Circuit High
- DTC P0269-00: Cylinder 3 Contribution/Balance
- DTC P0270-00: Cylinder 4 Injector Circuit Low
- DTC P0271-00: Cylinder 4 Injector Circuit High
- DTC P0272-00: Cylinder 4 Contribution/Balance
- DTC P0273-00: Cylinder 5 Injector Circuit Low
- DTC P0274-00: Cylinder 5 Injector Circuit High
- DTC P0275-00: Cylinder 5 Contribution/Balance
- DTC P0276-00: Cylinder 6 Injector Circuit Low
- DTC P0277-00: Cylinder 6 Injector Circuit High
- DTC P0278-00: Cylinder 6 Contribution/Balance
- DTC P0299-00: Turbocharger/Supercharger Underboost
- DTC P02CC-00: Cylinder 1 Fuel Injector Offset Learning At Min Limit
- DTC P02CD-00: Cylinder 1 Fuel Injector Offset Learning At Max Limit
- DTC P02CE-00: Cylinder 2 Fuel Injector Offset Learning At Min Limit
- DTC P02CF-00: Cylinder 2 Fuel Injector Offset Learning At Max Limit
- DTC P02D0-00: Cylinder 3 Fuel Injector Offset Learning At Min Limit
- DTC P02D1-00: Cylinder 3 Fuel Injector Offset Learning At Max Limit
- DTC P02D2-00: Cylinder 4 Fuel Injector Offset Learning At Min Limit
- DTC P02D3-00: Cylinder 4 Fuel Injector Offset Learning At Max Limit
- DTC P02D4-00: Cylinder 5 Fuel Injector Offset Learning At Min Limit
- DTC P02D5-00: Cylinder 5 Fuel Injector Offset Learning At Max Limit
- DTC P02D6-00: Cylinder 6 Fuel Injector Offset Learning At Min Limit
- DTC P02D7-00: Cylinder 6 Fuel Injector Offset Learning At Max Limit
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
