Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2017RIO EX, 4D HATCHBACKREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL RESTRAINT SYSTEM CONTROL MODULE AND SENSORSFRONT IMPACT SENSOR (FIS)REPAIR PROCEDURESREMOVAL
2017 Kia Rio EX, 4D Hatchback
Repair Procedures: Removal
2017 Kia Rio EX, 4D HatchbackSECTION Removal
CAUTION:
- Removal of the airbag must be performed according to the precautions/procedures described previously.
- Before disconnecting the front impact sensor connector, disconnect the front airbag connector (s).
- Do Not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
- Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
- Remove the front wheel guard.
(Refer to "EXTERIOR, FENDER ")
- Left side - Remove the air duct assembly.
Right side - Remove the washer reservoir.
(Refer to the FRONT WASHER MOTOR )
- Remove the front impact sensor (B) mounting bolt.
- Disconnect the front impact sensor connector (A).
- Remove the front impact sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.