Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2017RIO EX, 4D HATCHBACKREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (MANUAL TRANSAXLE CONTROL SYSTEM)BACK-UP LAMP SWITCHREPAIR PROCEDURESREPLACEMENT
2017 Kia Rio EX, 4D Hatchback
Repair Procedures: Replacement
2017 Kia Rio EX, 4D HatchbackSECTION Replacement
WARNING: This page is about a different variant/trim than selected.
- Disconnect the back up lamp switch connector (A).
- Remove the back up lamp switch (A).
- Replace a new one and install the back up lamp switch.
Tightening Torque:
29.4-34.3 N.m (3.0-3.5 kgf.m, 21.7-25.3 lb-ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.