Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
2017 Kia Rio EX, 4D HatchbackSECTION Component Inspection
■ Check Fuel Pump Relay
- Connect GDS to Data Link Connector (DLC).
- IG KEY "ON" & ENG "OFF"
- Perform "Actuation Test" for Fuel Pump Relay.
- Does the Fuel Pump Relay work normally? (Check clicking sound).
YES
- Substitute with a known-good ECU and check for proper operation. If the problem is corrected, replace ECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good EMS Box and check for proper operation. If the problem is corrected, replace EMS Box and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.