Repair Procedures: Removal

2017 Kia Rio EX, 4D HatchbackSECTION Removal
  1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - REPAIR PROCEDURES - "RELEASE RESIDUAL PRESSURE IN FUEL LINEΒ ").
  2. Remove the rear seat [LH] (Refer to "REAR SEAT ").
  3. Remove the fuel pump service cover (A).
    Fig 1: Removing Fuel Pump Service Cover
    G11845312Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the fuel pump connector (A).
  5. Disconnect the fuel feed tube quick connector (B).
  6. Disconnect the fuel tank pressure sensor connector (C).
  7. Disconnect the vapor tube quick-connector (D).
  8. Remove the plate cover (E) after removing the installation bolts, and then remove the fuel pump from the fuel tank.
Fig 2: Disconnecting Vapor Tube Quick-Connector
G11845313Courtesy of KIA MOTORS AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.