SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2017RIO EX, 4D HATCHBACKREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSCHARGING SYSTEMREPAIR PROCEDURESON-VEHICLE INSPECTION
2017 Kia Rio EX, 4D Hatchback

On-Vehicle Inspection

2017 Kia Rio EX, 4D HatchbackSECTION On-Vehicle Inspection

Information 

  • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC INDEX )
CAUTION:
  • Check that the battery cables are connected to the correct terminals.
  • Disconnect the battery cables when the battery is given a quick charge.
  • Never disconnect the battery while the engine is running.

[General Inspection] 

  1. Check The Battery Terminals And Fuses
    1. Check that the battery terminals are not loose or corroded.
    2. Check the fuses for continuity.
  2. Inspect Drive Belt
    1. Visually check the belt for excessive wear, frayed cords etc.

      If any defect has been found, replace the drive belt.

      NOTE:
      • Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.