Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2017RIO EX, 4D HATCHBACKREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKIGNITION SWITCH ASSEMBLYREPAIR PROCEDURESREMOVAL
2017 Kia Rio EX, 4D Hatchback
Repair Procedures: Removal
2017 Kia Rio EX, 4D HatchbackSECTION Removal
- Disconnect the Negative (-) Battery Terminal.
- Remove the Steering Column Upper and Lower Shrouds.
(Refer to "STEERING COLUMN ")
- Disconnect the ignition switch connector (B) and the key switch connector (A) from under the steering column.
- If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin with key ACC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.