Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Kia Niro EXFACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (6 Of 6)
- DTC Index
- DTC P2243-00: O2 Sensor Reference Voltage Circuit/Open (Bank 1 / Sensor 1)
- DTC P2251-00: O2 Sensor Reference Ground Circuit/Open (Bank 1 / Sensor 1)
- DTC P2270-00: O2 Sensor Signal Stuck Lean (Bank 1 / Sensor 2)
- DTC P2271-00: O2 Sensor Signal Stuck Rich (Bank 1 / Sensor 2)
- DTC P2297-00: O2 Sensor Out of Range During Deceleration (Bank 1 / Sensor 1)
- DTC P2414-00: O2 Sensor Exhaust Sample Error (Bank 1 / Sensor 1)
- DTC P2418-00: Evaporative Emission System Switching Valve Control Circuit/Open
- DTC P2419-00: Evaporative Emission System Switching Valve Control Circuit - Low
- DTC P2420-00: Evaporative Emission System Switching Valve Control Circuit - High
- DTC P2451-00: Evaporative Emission System Switching Valve Stuck Closed
- DTC P2540-00: Low Pressure Fuel System Sensor Circuit Range/Performance
- DTC P2541-00: Low Pressure Fuel System Sensor Circuit - Low
- DTC P2542-00: Low Pressure Fuel System Sensor Circuit - High
- DTC P2600-00: Coolant Pump 'A' Control Circuit/Open
- DTC P2601-00: Coolant Pump 'A' Control Circuit Range/Performance
- DTC P2610-00: ECM/PCM Internal Engine OFF Timer Performance
- DTC P261F-00: Coolant Pump 'A' Control Circuit Stuck ON
- DTC P2626-00: O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 / Sensor 1)
- DTC P262B-00: Control Module Power OFF Timer Performance
- DTC P26D0-00: Engine Coolant Pump Control Module System Voltage Low
- DTC P26D1-00: Engine Coolant Pump Control Module System Voltage High
- DTC P3190-00: Poor Engine Power
- DTC U0001-00: High Speed CAN Communication BUS OFF (C-CAN)
- DTC U0101-00: Lost Communication with TCM (C-CAN)
- DTC U0109-00: Lost Communication With Fuel Pump Control Module
- DTC U0110-00: Lost Communication With Drive Motor Control Module
- DTC U0111-00: Lost Communication With Battery Energy Control Module 'A' (C-CAN)
- DTC U0293-00: Lost Communication With Hybrid Powertrain Control Module (C-CAN)
- DTC U029F-00: Lost Communication With Evaporative Emission System Leak Detection Control Module Guide
- DTC U0456-00: Invalid Data Received From Coolant Temperature Control Module
- DTC U1001-00: High Speed CAN Communication BUS (H-CAN)
- DTC U1003-00: Lost Communication With TCM (H-CAN)
- DTC U1004-00: Lost Communication With Hybrid Powertrain Control Module (H-CAN)
- DTC U1008-00: Lost Communication With Radiator Shutter (Active Air Flap) (C-CAN)
- DTC U1111-00: LIN Message Time-Out With EBS
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
