SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL EV BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSREAR DOOR ASSEMBLYREAR DOOR LATCHREPAIR PROCEDURESREPLACEMENT
2015 Kia Soul EV Base

Repair Procedures: Replacement

2015 Kia Soul EV BaseSECTION Replacement
  1. Remove the rear door module.

    (Refer to Rear Door - "REAR DOOR MODULE ")

  2. Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.
    Fig 1: Rear Door Outside Handle Base Lock Pins
    G10727689Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the rear door outside handle cable (A).
    Fig 2: Rear Door Outside Handle Cable
    G10727690Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the rear door latch connector (A).
  5. Remove the rear door latch assembly (B) by pulling it in the direction of the arrow.
    Fig 3: Rear Door Latch Assembly
    G10727691Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the rear door inside handle cage (A).
    Fig 4: Rear Door Inside Handle Cage
    G10727692Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the rear door inside handle cable (A) by pushing it backward.
    Fig 5: Pushing Rear Door Inside Handle Cable Backward
    G10727693Courtesy of KIA MOTORS AMERICA, INC.
  8. Install in the reverse order of removal.

    Information 

    • Make sure that the connectors are connected properly.
    • Make sure that the door locks/unlocks and opens/closes properly.
    • Replace any damaged clips.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.