Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL EV +REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTPARKING ASSIST SYSTEMPARKING ASSIST SENSORREPAIR PROCEDURESREMOVAL
2015 Kia Soul EV +
Repair Procedures: Removal
2015 Kia Soul EV +SECTION Removal
- Disconnect the negative (-) battery terminal.
- Remove the front/rear bumper cover.
(Refer to Body - "FRONT BUMPER COVER ")
(Refer to Body - "REAR BUMPER COVER ")
- Disconnect the connector (A) from the ultrasonic sensor.
[Front sensor, Rear center sensor]
Courtesy of KIA MOTORS AMERICA, INC.
[Rear side sensor]
- Pull out ths ultrasonic sensor (A) by opening the sensor holder out.
[Front sensor, Rear center sensor]
[Rear side sensor]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.