Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLELECTRONIC STABILITY CONTROL (ESC) SYSTEM DIAGNOSISDTC C1208: WHEEL SPEED SENSOR REAR-LH INVALID/NO SIGNALCOMPONENT INSPECTION
2015 Kia Soul Base, Standard Trans
Component Inspection
2015 Kia Soul Base, Standard TransSECTION Component Inspection
- IG Key "OFF".
- Disconnect HECU connector.
- Measure resistance between Pin No. 1 (Signal) terminal and Pin No. 2 (Power) terminal of the Rear LH Wheel Speed Sensor. (Component Side)
Specification: Approx. 3.899 MΩ
- Is the resistance of Rear LH wheel speed sensor similar as shown in illustration?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace wheel speed sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.