SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMHEAD LAMPSREPAIR PROCEDURESREPLACEMENTHEAD LAMP AND FOG LAMP AIMING POINT
2015 Kia Soul Base, Standard Trans

Head Lamp And Fog Lamp Aiming Point

2015 Kia Soul Base, Standard TransSECTION Head Lamp And Fog Lamp Aiming Point
Fig 1: Identifying Head Lamp And Fog Lamp Aiming Point (Standard)
G09778276Courtesy of KIA MOTORS AMERICA, INC.
Unit: in (mm)
Vehicle condition H1 H2 W1 W2 L
Without driver 33.5(850) 14.8(377) 52.5(1, 344) 49.0(1, 244) Refer to aiming condition
With driver 33.2(843) 14.6(370)
Fig 2: Identifying Head Lamp And Fog Lamp Aiming Point (Option)
G09778277Courtesy of KIA MOTORS AMERICA, INC.
Unit: in (mm)
Vehicle condition H1 H2 H3 W1 W2 W3 L
Without driver 33.2(843) 33.1(840) 14.8(377) 53.7(1, 364) 43.7(1, 110) 49.0(1, 244) Refer to aiming condition
With driver 32.9(836) 33.0(833) 14.6(370)
  1. Head Lamp (Low beam)
    1. Turn the low beam on without driver aboard.
    2. The cut-off line should be projected in the cut-off line shown in the picture.
    3. If head lamp leveling device is equipped, adjust the head lamp leveling device switch with 0 positions.
      Fig 3: Identifying Head Lamp W1 (Low Beam) Adjustment Screen
      G09778278Courtesy of KIA MOTORS AMERICA, INC.
  2. Turn the front fog lamp on without the driver aboard.

    The cut-off line should be projected in the allowable range (shaded region)

    Fig 4: Identifying Front Fog Lamp Cut-Off Line (Shaded Region) Adjustment Screen
    G09778279Courtesy of KIA MOTORS AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.