Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, AUTOMATIC TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE CONTROL SYSTEM - 1.6LTRANSAXLE OIL TEMPERATURE SENSORREPAIR PROCEDURESREMOVAL
2015 Kia Soul Base, Automatic Trans
Repair Procedures: Removal
2015 Kia Soul Base, Automatic TransSECTION Removal
- Change the shift lever to "N" range.
- Remove the valve body assembly.
(Refer to "FLUID ")
- Disconnect the input & output speed sensor connector (A).
- Loosen the main connector bolt (B).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- Disconnect the solenoid valve connector (A).
- Remove the solenoid valve connector clip (B) after loosening a bolt and then remove the connector by pushing down to it.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.