SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, AUTOMATIC TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE CONTROL SYSTEM - 1.6LSHIFT CABLEREPAIR PROCEDURESREMOVAL
2015 Kia Soul Base, Automatic Trans

Repair Procedures: Removal

2015 Kia Soul Base, Automatic TransSECTION Removal
  1. Remove the floor console assembly.

    (Refer to "FLOOR CONSOLE ")

  2. Remove the rear heating joint duct (A).
    Fig 1: Rear Heating Joint Duct
    G09773297Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the shift cable (A) from the shift lever assembly.
    Fig 2: Removing Shift Cable From Shift Lever Assembly
    G09773298Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the retainer (A) by loosening the nuts (B).

    Tightening torque: 

    11.8 ~ 14.7 N.m (1.2 ~1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

    Fig 3: Shift Cable Retainer & Nut
    G09773299Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the air cleaner assembly and air duct.

    (Refer to "AIR CLEANER ")

  6. Battery and battery tray.

    (Refer to "BATTERY ")

  7. Remove the shift cable from the transaxle.
    1. Remove the nut (C) from the manual control lever.

      Tightening torque: 

      9.8 ~ 13.7 N.m (1.0 ~1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

    2. Remove the cable (B) from the bracket (A).
      Fig 4: Manual Control Lever Cable, Bracket & Mounting Nut
      G09773300Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the shift cable by pulling it toward the interior.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.