Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSMART KEY SYSTEMSMART KEY DIAGNOSTICREPAIR PROCEDURESINSPECTIONSERIAL COMMUNICATION STATUS CHECK
2015 Kia Soul Base, Automatic Trans
Serial Communication Status Check
2015 Kia Soul Base, Automatic TransSECTION Serial Communication Status Check
- Connect the cable of GDS to the data link connector in driver side crash pad lower panel.
- Select the "Serial Communication Line Check".
- After IGN ON, select the "Receiver Communication Line Check".
- Check the serial communication line with a GDS.
- If the smart key runs normal, the communication of smart key unit, exterior receiver are normal.
- If the smart key runs abnormal, check the following items.
- Disconnection or no response of the exterior receiver communication line.
- The exterior receiver communication line disconnection and ground connection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.