Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Monitor GDS Data
2015 Kia Soul +SECTION Monitor GDS Data
- Check antenna coil(+,-) communication
- Ignition "OFF"
- Connect GDS and setup the oscilloscope.
- Back probe and measure signal waveform of Pin No. 2 (Coil (+)) terminal of antenna coil(+) and chassis ground with VMI.
- Back probe and measure signal waveform of Pin No. 1 (Coil (-)) terminal of antenna coil(-) and chassis ground with VMI.
- Ignition "ON", Engine "OFF"
Specification: Refer to Fig 1 below
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.