Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSKIA2015SOUL !REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKIGNITION SWITCH ASSEMBLYREPAIR PROCEDURESREMOVAL

2015 Kia Soul !

Repair Procedures: Removal

2015 Kia Soul !SECTION Removal

Disconnect the negative (-) battery terminal.
Remove the crash pad lower panel.
(Refer to "CRASH PAD LOWER PANEL ")
Remove the steering column upper and lower shrouds.
(Refer to "STEERING COLUMN SHROUD PANEL ")
Remove the wiper switch.
(Refer to MULTIFUNCTION SWITCH )
Remove the ignition switch after loosening disconnecting the ignition switch 6P connector (A).

Fig 1: Identifying Ignition Switch 6P Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the ignition switch assembly (A) after loosening the mounting bolts.

Fig 2: Identifying Ignition Switch Assembly
Courtesy of KIA MOTORS AMERICA, INC.
If it is necessary to remove the key lock cylinder (A), it is in the order as below.
1. Disconnect the key warning/immobilizer connector (A)
  
  Fig 3: Identifying Key Warning/ Immobilizer Connector
  Courtesy of KIA MOTORS AMERICA, INC.
2. Turn the key to ACC (A).
  
  Fig 4: Turning Key To ACC
  Courtesy of KIA MOTORS AMERICA, INC.
3. Remove the key lock cylinder (B) while pushing the removal/installation button under the key cylinder (A).
  
  Fig 5: Identifying Key Lock Cylinder
  Courtesy of KIA MOTORS AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.