SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SEDONA SXLREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEMHEATED OXYGEN SENSOR (HO2S)REPAIR PROCEDURESREMOVAL
2015 Kia Sedona SXL

Repair Procedures: Removal

2015 Kia Sedona SXLSECTION Removal
NOTE: Note that the SST (Part No: 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor.

[Bank 1/Sensor 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 1: Heated Oxygen Sensor Connector (Bank 1/Sensor 1)
    G10648880Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 2: Heated Oxygen Sensor (Bank 1/Sensor 1)
G10648881Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Sensor 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 3: Heated Oxygen Sensor Connector (Bank 1/Sensor 2)
    G10648882Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 4: Heated Oxygen Sensor (Bank 1/Sensor 2)
G10648883Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2/Sensor 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 5: Heated Oxygen Sensor Connector (Bank 2/Sensor 1)
    G10648884Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 6: Heated Oxygen Sensor (Bank 2/Sensor 1)
G10648885Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2/Sensor 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
  3. Remove the heated oxygen sensor (B).
Fig 7: Heated Oxygen Sensor And Connector (Bank 2/Sensor 2)
G10648886Courtesy of KIA MOTORS AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.