Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Start/Stop Button (SSB)
A single stage push button is used by the driver to operate the vehicle. By pressing this button, the driver can:
- Switch between corresponding terminals to operate power modes "Off", "Accesory", "Ignition" and "Start"
- To start the engine
- To stop the engine
A backlighting is integrated to illuminate the button for the driver to easily locate the button.
Three-colored (3) LED lamps are located on the outer ring of the switch assy to display the status of the system: OFF (Clear)/ACC (Amber)/ON (Green).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.