Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SEDONA EXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSSMART CRUISE CONTROL SYSTEM DIAGNOSIS
2015 Kia Sedona EX
Smart Cruise Control System Diagnosis
2015 Kia Sedona EXSECTION Smart Cruise Control System Diagnosis
- DTC Index
- DTC C1101-01: Battery Voltage High
- DTC C1102-01: Battery Voltage Low
- DTC C1202-08: Wheel Speed Sensor Front-LH Invalid/No Signal
- DTC C1205-08: Wheel Speed Sensor Front-RH Invalid/No Signal
- DTC C1208-08: Wheel Speed Sensor Rear-LH Invalid/No Signal
- DTC C1211-08: Wheel Speed Sensor Rear-RH Invalid/No Signal
- DTC C1260-08: Steering Angle Sensor Circuit-Signal
- DTC C1283-08: Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error
- DTC C1360-08: ESP Irreversible Error
- DTC C1604-04: ECU Hardware Error
- DTC C1611-08: CAN Time-Out EMS
- DTC C1612-08: CAN Time-Out TCU
- DTC C1616-08: C-CAN Bus OFF
- DTC C1617-08: EMS Invalid Engine Speed
- DTC C1620-07: Alignment Failed
- DTC C1623-08: CAN Time-Out Steering Angle Sensor
- DTC C1625-08: CAN Time-Out ABS/ESP
- DTC C1628-08: CAN Time-Out Cluster
- DTC C1629-08: Cluster Invalid Counter
- DTC C1632-08: Cluster Control Switch Fail
- DTC C1633-08: Cluster Invalid Displayed Speed
- DTC C1635-08: TCS Invalid Counter
- DTC C1638-08: ACC Communication Error
- DTC C1642-08: CAN Message Failure - Brake
- DTC C1646-08: CAN Message Failure - TCU
- DTC C1742-08: Variant Error - ESC (Check ESC)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.