Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Signal Circuit Inspection
2015 Kia Optima SXSECTION Signal Circuit Inspection
- Lift vehicle with suitable lift and refer to shop handbook to remove wheel and wheel guard.
- Ignition "ON".
- Rotate the disc slowly by hands.
- Back probe and measure signal waveform between signal terminal of Front RH wheel speed sensor and chassis ground with GDS.
Specification : High : 1.18 ~ 1.68V, Low : 0.59 ~ 0.84V
Fig.1) Normal wheel speed sensor signal waveform when rotating wheel.
- Is the measured waveform within specifications ?
YES
- Go to COMPONENT INSPECTION procedure.
NO
- Repair open or short in signal circuit between HECU and Front RH wheel speed sensor harness connector and then go to VERIFICATION OF VEHICLE REPAIR procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.