Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Trunk Lid Assembly Replacement
2015 Kia Optima SXSECTION Trunk Lid Assembly Replacement
CAUTION:
- When removing and installing the trunk lid, an assistant is necessary.
- Wear gloves to protect hands from injury.
- Loosen the trunk inside handle (A) mounting screws.
- Detach the clips, then remove the trunk lid trim (A).
- Disconnect wiring (B) and connectors.
- After loosening the mounting bolts, then remove the trunk lid (A).
Tightening Torque:
6.9~8.8 N.m (0.7~0.9 kgf.m, 5.1~6.5 lb-ft)
- Installation is the reverse of removal.NOTE:
- Replace any damaged clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.