Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Monitor Scantool Data
2015 Kia Optima SXSECTION Monitor Scantool Data
- Check status.
- IGN "ON" & Engine "OFF".
- Monitor the "ECM, Key and Smartra Status" Parameter on the Current Data
menu of the GDS.
Specification : 'LEARNT'
- Is the "ECU STATUS" Parameter "Locked"?
YES
- Keep "KEY ON" status for 1 hours to withdraw "Locked by Timer" status. Then turn the key OFF for 10 seconds. Next register transponder and go to VERIFICATION OF VEHICLE REPAIR procedure.
NO
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the PCM or SMARTRA. And this DTC has not erased in previous repair. Repair or replace necessary and then go to VERIFICATION OF VEHICLE REPAIR procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.