Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Inspection: Notes
2015 Kia Optima SXSECTION Notes
- Check-points upon head lamp failure (HID)
- Check the battery voltage. (Low beam will be on when the battery voltage above 9V.)
- Check the fuse and relay.
- Check the polarity of ballast. (If the polarity are changed, low beam doesn't lighten)
- Check the bulb connector securely.
- Visually bulb checking (no filament): damaged glass, damaged for upper parts and lower parts of glass tube.
- After (1)~(5), replace the ballast and the ignitor. (ballast assembly).CAUTION: If a headlamp goes out after a period of operation but will immediately relights when the headlamp switch is cycled it is likely the HID lamp needs to be replaced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.