SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015OPTIMA SXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSIMMOBILIZER SYSTEM DIAGNOSIS - OPTIMA (EXCEPT HEV)DTC P1676: IMMOBILIZER - SMARTRA MESSAGE ERRORGENERAL INFORMATIONGENERAL DESCRIPTION
2015 Kia Optima SX

General Information: General Description

2015 Kia Optima SXSECTION General Description
  1. The sequences of the PIN code storage are as follows.
    1. Input the PIN code into the scanner when key teaching process.

      The scanner transmits the Encrypted Code to the PCM after converting the PIN code into Encrypted Code.

    2. When the PCM gets the first key learning command, it transmits the SMARTRA3 learnt command and Encrypted Code to the SMARTRA3.
    3. If the SMARTRA3 statue is virgin/neutral, the SMARTRA3 stores Encrypted Code in EEPROM and transmits the success message of the Encrypted Code storage.

      (If the SMARTRA3 is learnt, the SMARTRA3 compares Encrypted Code transmitted by the PCM with Encrypted Code stored in EEPROM and transmits the (in)correct Encrypted Code message to PCM).

    4. If the SMARTRA3 is learned normally or the Encrypted Code of the registered SMARTRA3 is the same as the PCM, the PCM begins operation the Transponder Learning.
    5. If the learning of the first transponder, the PCM stores the Encrypted Code in its EEPROM and converts state into learnt state.
  2. The SMARTRA3 learning :
    1. starts with EMS request of PIN from scanner through the key teaching procedure.
    2. is possible in case that the status of SMARTER is "virgin" or "neutral".
    3. In case that the SMARTRA3 is "learnt", the SMARTRA3 will transmits the information if PIN inputted from scanner is same as the PIN in SMARTRA3.
    4. is possible regardless of key status.
  3. The sequence of the SMARTRA3 confirms are as follows.
  1. After communication with the SMARTRA3, the PCM transmits the random number with requirement of the TP ID information.
  2. The SMARTRA3 encrypts the random number and transmits the result (Encrypted Random Number) to the PCM with TP ID information.
  3. The PCM compares the result transmitted from the SMARTRA3 with the result calculated by PCM.

    And If result are coincided with each other; the ECS concludes the valid confirmation of the SMARTRA3.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.