Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015OPTIMA SX TURBOREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 107 (ENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - 2.4L (EXCEPT HEV))DTC P0444: EVAPORATIVE EMISSION SYSTEM - PURGE CONTROL VALVE CIRCUIT OPENCOMPONENT INSPECTIONCOMPONENT INSPECTION_1
2015 Kia Optima SX Turbo
Component Inspection_1
2015 Kia Optima SX TurboSECTION Component Inspection_1
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF"
- Disconnect PCSV connector.
- Measure resistance between power terminal and signal terminal of PCSV connector (Component side).PCSV RESISTANCE AND TEMPERATURE SPECIFICATIONS
Temp. (°C) Temp. (°F) PCSV Resistance (Ω) 20 68 19 ~ 22 - Is resistance within the specification?
YES
- Go to next step as indicated below.
NO
- Check PCSV for contamination, deterioration, or damage. Substitute with a known-good PCSV and check for proper operation. If the problem is corrected, replace PCSV and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.