Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015OPTIMA LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESELECTRONIC STABILITY CONTROL SYSTEM DIAGNOSIS - OPTIMA (EXCEPT HEV)
2015 Kia Optima Limited
Electronic Stability Control System Diagnosis - Optima (Except HEV)
2015 Kia Optima LimitedSECTION Electronic Stability Control System Diagnosis - Optima (Except HEV)
- DTC Index
- DTC C1101: Battery Voltage High
- DTC C1102: Battery Voltage Low
- DTC C1112: Sensor Source Voltage
- DTC C1200: Wheel Speed Sensor Rear - LH Open/Short
- DTC C1201: Wheel Speed Sensor Rear - LH Range Performance Intermittent
- DTC C1202: Wheel Speed Sensor Rear - LH Invalid No Signal
- DTC C1203: Wheel Speed Sensor Rear - RH Open/Short
- DTC C1204: Wheel Speed Sensor Front - LH Open/Short
- DTC C1205: Wheel Speed Sensor Front - LH Range Performance Intermittent
- DTC C1206: Wheel Speed Sensor Front - LH Invalid No Signal
- DTC C1207: Wheel Speed Sensor Front - RH Open/Short
- DTC C1208: Wheel Speed Sensor Front - RH Range / Performance / Intermittent
- DTC C1209: Wheel Speed Sensor Front - RH Invalid No Signal
- DTC C1210: Wheel Speed Sensor Rear - RH Range Performance Intermittent
- DTC C1211: Wheel Speed Sensor Rear - RH Invalid No Signal
- DTC C1235: Primary Pressure Sensor - Electrical
- DTC C1260: Steering Angle Sensor Circuit - Signal
- DTC C1261: Steering Angle Sensor Not Calibrated
- DTC C1282: Yaw Rate & Lateral G Sensor - Electrical
- DTC C1283: Yaw Rate & Lateral G Sensor - Signal
- DTC C1285: Longitudinal G-Sensor Not Calibrated
- DTC C1358: AVH Switch Error
- DTC C1503: TCS/ESC (ESP) Switch Error
- DTC C1513: Brake Switch Circuit Error
- DTC C1520: Clutch Signal Error
- DTC C1527: Gear R Switch Error
- DTC C1604: ECU Hardware Error
- DTC C1605: CAN Hardware Error
- DTC C1611: CAN Time-Out ECM
- DTC C1612: CAN Time-Out TCM
- DTC C1613: CAN Signal Error ECM (Check ECM)
- DTC C1616: CAN Bus OFF
- DTC C1623: CAN Time-Out Steering Angle Sensor
- DTC C1628: CAN Time-Out Cluster
- DTC C1647: CAN Hardware Error - Sensor Channel
- DTC C1651: CAN Time-Out EPB
- DTC C1652: CAN Signal Error EPB
- DTC C1656: CAN Signal Error Cluster
- DTC C1687: CAN Time-Out VSM2 (MDPS)
- DTC C1688: VSM2 (MDPS) Signal Error
- DTC C1702: Variant Coding Error
- DTC C2112: Valve Relay Error
- DTC C2130: Brake Lamp Relay Error
- DTC C2131: ESS Brake Lamp Relay Error
- DTC C2227: Excessive Temperature Of Brake Disc
- DTC C2380: ABS/TCS/ESC (ESP) Valve Error
- DTC C2402: Motor Failure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.