Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
ETC Module Learning Procedure
2015 Kia K900 V8SECTION ETC Module Learning Procedure
WARNING: This page is about a different car, the 2016 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.
Be sure to perform the ETC module learning procedure when replacing or re-installing the ETC module.
- Wait for 1 minute with the Ignition Switch ON.
- Start the Engine and hold the idle status for 15 minutes.
- Waif for 1 minute with the Ignition Switch OFF.
- Restart the Engine, check that the idle speed is stable.NOTE: If not performing the ETC module learning procedure after replacing or re-installing, MIL illumination with DTCs might occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.