Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V6REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXTIRE PRESSURE MONITORING SYSTEM DTCS
2015 Kia K900 V6
Tire Pressure Monitoring System DTCS
2015 Kia K900 V6SECTION Tire Pressure Monitoring System DTCS
TIRE PRESSURE MONITORING SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C1121 | Front Left Sensor Battery Voltage Low |
| C1122 | Front Right Sensor Battery Voltage Low |
| C1123 | Rear Left Sensor Battery Voltage Low |
| C1124 | Rear Right Sensor Battery Voltage Low |
| C1126 | TPMS ECU Battery Voltage Low |
| C1127 | TPMS ECU Battery Voltage High |
| C1212 | Vehicle Speed Sensor |
| C1312 | Front Left Sensor RF Channel Failure |
| C1313 | Front Right Sensor RF Channel Failure |
| C1314 | Rear Left Sensor RF Channel Failure |
| C1315 | Rear Right Sensor RF Channel Failure |
| C1322 | Front Left Sensor Over Temperature |
| C1323 | Front Right Sensor Over Temperature |
| C1324 | Rear Left Sensor Over Temperature |
| C1325 | Rear Right Sensor Over Temperature |
| C1332 | Front Left Sensor Fault |
| C1333 | Front Right Sensor Fault |
| C1334 | Left Rear Sensor Fault |
| C1335 | Rear Right Sensor Fault |
| C1611 | CAN Time-out EMS |
| C1613 | CAN signal error EMS (Check EMS) |
| C1616 | CAN Bus OFF |
| C1642 | CAN Message Failure - Brake |
| C1660 | Receiver RF Circuit Fail |
| C1662 | Auto Learning failure |
| C1663 | Auto Location Failure |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.