Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V6REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXBLIND SPOT DETECTION SYSTEM DTCS
2015 Kia K900 V6
Blind Spot Detection System DTCS
2015 Kia K900 V6SECTION Blind Spot Detection System DTCS
BLIND SPOT DETECTION SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C110117 | Battery Voltage High |
| C110216 | Battery Voltage Low |
| C128381 | Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error |
| C150101 | Switch Failure |
| C160A88 | BSD Local CAN bus off |
| C161187 | CAN Time-out EMS |
| C161287 | CAN Time-out TCU |
| C161381 | CAN signal error EMS |
| C161688 | CAN Bus OFF (C-CAN) |
| C162587 | CAN Time-out ABS/ESC (ESP) |
| C162887 | CAN Time-out Cluster |
| C164681 | CAN Message Failure - TCU |
| C170255 | Variant Coding Error |
| C170A11 | Activation Switch LED Circuit short to ground |
| C170B12 | Activation Switch LED Circuit short to battery or open |
| C170C04 | ECU Hardware error (REAR RIGHT) |
| C170D04 | ECU Hardware error (REAR LEFT) |
| C174305 | Software Mis-Match |
| C270254 | Control Module Master Missing Calibration |
| C270354 | Control Module Slave Missing Calibration |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.