Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V6REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEBLIND SPOT DETECTION SYSTEM DIAGNOSIS
2015 Kia K900 V6
Blind Spot Detection System Diagnosis
2015 Kia K900 V6SECTION Blind Spot Detection System Diagnosis
- DTC Index
- DTC C1101-17: Battery Voltage High
- DTC C1102-16: Battery Voltage Low
- DTC C1283-81: Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error
- DTC C1501-01: Switch Failure
- DTC C160A-88: BSD Local CAN Bus Off
- DTC C1611-87: CAN Time-Out EMS
- DTC C1612-87: CAN Time-Out TCU
- DTC C1613-81: CAN Signal Error EMS
- DTC C1616-88: CAN Bus OFF (C-CAN)
- DTC C1625-87: CAN Time-Out ABS/ESC (ESP)
- DTC C1628-87: CAN Time-Out Cluster
- DTC C1646-81: CAN Message Failure - TCU
- DTC C1702-55: Variant Coding Error
- DTC C170A-11: Activation Switch LED Circuit Short To Ground
- DTC C170B-12: Activation Switch LED Circuit Short To Battery Or Open
- DTC C170C-04: ECU Hardware Error (Rear Right)
- DTC C170D-04: ECU Hardware Error (Rear Left)
- DTC C1743-05: Software Mis-Match
- DTC C2702-54: Control Module Master Missing Calibration
- DTC C2703-54: Control Module Slave Missing Calibration
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.