SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015FORTE5 SX, STANDARD TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSMANUAL TRANSAXLE CONTROL SYSTEM - 1.6LCONTROL CABLEREPAIR PROCEDURESINSTALLATION
2015 Kia Forte5 SX, Standard Trans

Repair Procedures: Installation

2015 Kia Forte5 SX, Standard TransSECTION Installation
NOTE:
  • When installing, set room side Shift lever and T/M side lever to N position.
  1. Install the control cable (B) and clip (A) on the bracket.
    Fig 1: Control Cable And Clip
    G09747064Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the washer (B) and pin (A).
    Fig 2: Locating Washer And Pin
    G09747065Courtesy of KIA MOTORS AMERICA, INC.
  3. Tighten the nut (B) after install the retainer (A).

    Tightening Torque: 

    11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

    Fig 3: Nut And Retainer
    G09747066Courtesy of KIA MOTORS AMERICA, INC.
  4. Install the cable socket (A) on the shift lever assembly.
    Fig 4: Cable Socket On Shift Lever Assembly
    G09747067Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the shift cable (B) and clip (A).
    Fig 5: Shift Cable And Clip
    G09747068Courtesy of KIA MOTORS AMERICA, INC.
  6. Shift lever to "3rd".
  7. Install the snap pin (A) after install the select cable (B).
    CAUTION:
    • Install the snap pin (A) after adjust the select cable (B).

      (Refer to "ADJUSTMENT ")

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.