Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015FORTE5 SX, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 2) - 1.6LDTC P0230: FUEL PUMP PRIMARY CIRCUITCOMPONENT INSPECTION
2015 Kia Forte5 SX, Standard Trans
Component Inspection
2015 Kia Forte5 SX, Standard TransSECTION Component Inspection
- Inspection Fuel Pump Relay
- Connect GDS to Data Link Connector (DLC).
- IG KEY "ON" & ENG "OFF".
- Perform "Actuation Test" for Fuel Pump.
- Confirm Part Inspection
- Does the Fuel Pump operate properly? (Check variation)
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good Fuel Pump Relay and check for proper operation. If the problem is corrected, replace Fuel Pump Relay and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Does the Fuel Pump operate properly? (Check variation)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.