Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSKIA2015FORTE5 SX, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 2) - 1.6LDTC P0122: THROTTLE POSITION SENSOR 1 SIGNAL CIRCUIT LOW INPUTSYSTEM INSPECTION

2015 Kia Forte5 SX, Standard Trans

System Inspection

2015 Kia Forte5 SX, Standard TransSECTION System Inspection

Resetting Adaptive Values
1. Connect GDS to DLC (Data Link Cable).
2. IG "ON" & ENG "OFF"
3. Select the "Vehicle S/W Management" about related DTC with GDS.
  
  Fig 1: Scantool Display - Resetting Adaptive Values
  Courtesy of KIA MOTORS AMERICA, INC.
4. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  
  Fig 2: Scantool Display - Resetting Adaptive Values
  Courtesy of KIA MOTORS AMERICA, INC.
5. Press "Reset" button to progress for next procedure.
  
  Fig 3: Scantool Display - Resetting Adaptive Values Confirmation
  Courtesy of KIA MOTORS AMERICA, INC.
6. Press "OK" button (IG ON, ENG OFF).
  
  Fig 4: Scantool Display - Resetting Adaptive Values Completed
  Courtesy of KIA MOTORS AMERICA, INC.
7. When the "Resetting Adaptive Values" has been finished perfectly, press "OK" button and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.